For dependable static sealing, the Trojan Isolation gasket is a must. Trojan Isolation kit gaskets are state-of-the-art in near zero leakage static sealing. The Trojan elastomer sealing element is encapsulated in the electrically isolated retainer. The encapsulation of the sealing element permits only micro exposure of the seal to hostile environments of fire, chemicals and corrosive fluids. Our most popular sealing element materials are Nitrile®. The controlled confinement of the elastomer sealing ring within the retainer allows for the availability of a 92% to 94% volume filled groove. A consistent controlled pressure seal can always be obtained without tremendous bolt loads. Reduced loads allow for reduced flange thickness with smaller circles and smaller bolt holes. Seal Materials Available: Nitrile Viton EPDM PTFE The Trojan is also available in different configurations, including – Duplex Seal Trojan Four seals on the new Duplex-Seal Trojan further insure the integrity of the sealing capability of an already proven reliable gasket. For areas where absolute zero leakage is a must, the Duplex-Seal Trojan works twice as hard. Trojan Water Meter Trojan G-10 cathodic water meter isolating gaskets are NSF-61 approved and state of the art in near zero leakage static sealing for use in preventing galvanic reaction from the use of dissimilar metals on water piping such as steel or cast iron to brass. The elastomer sealing element is encapsulated in the electrically isolating retainer. The encapsulation of the sealing element permits only micro exposure of the seal to potable water flow. G-10 Gasket Kits are designed to keep any and all electrical currents from running back to the water meter. Advantages of the Trojan and Trojan II Large selection of materials available Reusable with Low installation and maintenance costs Seal design tested for high pressures (contact sales technician for specific pressures) Little initial torque required Can be utilized with mismatched and misaligned flanges Can be used in place of RJT (Ring Type Joints) No re-torquing required Sealing ring cannot be left out / Greatly reduces human error during installation Limited area of seal exposed Three to four times the dielectric strength necessary Contact one of our sales technicians for further information or download the attached datasheet.
